Pay Attention To The Following Points When Using A Sledgehammer
Nov 12, 2020
(1) The connection between the hammer head and the handle must be firm. Any hammer head and handle are loose, and the hammer handle has splits and cracks. The hammer head and hammer handle are wedge-fitted in the mounting hole. Metal wedge is better. The length of the wedge should not be greater than 2/3 of the depth of the mounting hole.
(2) In order to have a certain degree of elasticity when hitting, the top part of the handle should be slightly narrower than the end.
(3) When using a sledgehammer, you must pay attention to the front and back, left and right, up and down. It is strictly forbidden to stand within the scope of the sledgehammer's movement, and it is not allowed to use the sledgehammer and the small hammer to hit each other.
(4) The hammer head is not allowed to be quenched, and cracks and burrs are not allowed. If the flash is found, it should be repaired in time.
The claw hammer can be used to strike, hammer, and pull nails, but the claw hammer should not be used for hammering larger workpieces. When nailing a nail, the hammer head should strike the nail cap flat so that the nail enters the wood vertically. When pulling the nail, a wooden block should be placed on the claw to increase the pulling force. The claw hammer should not be used as a prying tool. Pay attention to hammering The surface is flat and intact to prevent the nail from flying out or the hammer from slipping off and hurting people.
